Proper Biscuit Spacing

I recently was asked the following questions about biscuit joinery:

"I'm using a biscuit joiner to glue up boards for a table top. What size biscuits should I use? How far apart should I space the biscuits?"

When using biscuits, you should always use the largest biscuits you can. In most cases, you'll use a #20 biscuit, but if this is too large, you can try a #10 or even #0 biscuit (for the smallest joints). Your biscuit joiner should be adjustable to accommodate all three common biscuit sizes.

As far as how far apart to space the biscuits, this is really up to you, as long as you follow some basic guidelines. The biscuits on the edges of the joint should be no more than 2-3" from the edge of the joint. Once you've determined the positions for the edge biscuits, you can evenly space an appropriate number of biscuits between the two end biscuits, spacing them between anywhere 6-12" apart.

More on woodworking tips & Plans, visit here

Biscuit Joints

For certain types of woodworking joints such as edge-to-edge joints, miter joints, T-joints and corner joints, there is hardly a better choice than biscuit joints. Properly-cut biscuit joints are strong and accurate, particularly when cutting slots with a woodworking tool called a biscuit joiner (or plate joiner).The most common type of biscuit joints are edge-to-edge joints. This is often used for gluing up table tops of various width boards of the same thickness, where biscuits are used along the planed long edges of the boards.

To glue up a table top of various boards, lay out the boards side-by-side with each board's end grain turned in the opposite direction of that of the previous board. This will help keep the table-top stable when the boards expand or shrink.

Once the boards are in the proper positions, use a pencil to make marks across the joints every 4-6". These will be the centerlines for the biscuit slots.

Next, separate the boards and adjust your biscuit joiner for the appropriate size of biscuit. In the case of edge-to-edge joints, you'll most likely use the large #20 size.

Placing the guide fence on top of the stock (perpendicular to the edge), align the cutting guide with the pencil mark. Hold the fence in place, start up the saw and once the motor is at full speed, smoothly plunge the blade into the stock until you can't push any farther. Then, retract the blade fully and repeat at the next mark.

The Finest Woodworking Plans Are Found By Clicking Here.

Biscuit Joinery

Every house, garage or shed needs strong, sturdy shelves. While the main purpose of a utility shelf is, well, utilitarian, it doesn't have to look that way. With a little bit of planning, you can make some utility shelves that look as good as they are strong. In these free woodworking plans, find step-by-step instructions for building some very useful (and good-looking) utility shelves.

The Finest Woodworking Plans Are Found By Clicking Here.